Material compatibility
What materials the Anycubic Kobra 2 can print
This comes from four facts on its spec sheet: the nozzle reaches 260 °C, the bed 110 °C, and the machine is open-frame with a direct-drive extruder. Those four facts decide most of the list: nozzle temperature sets the ceiling on what you can melt, the bed decides whether the first layer sticks, the enclosure keeps large parts from warping, and the extruder type rules flexibles. We don't test the machine — this is guidance derived from verified data, not a guarantee.
In short: it prints PLA, PETG, TPU (flexible) without a fight, and it can reach ABS, ASA, Nylon (PA) with conditions — the detail for each is below.
- PLAYes
Yes. PLA has no special needs: any FDM printer like the Kobra 2 prints it out of the box.
- PETGYes
Yes. With a nozzle up to 260 °C and a bed up to 110 °C it comfortably meets PETG's needs.
- TPU (flexible)Yes
Yes. It has a direct-drive extruder, ideal for flexibles; prints TPU well (go slow).
- ABSWith caveats
With caveats. It reaches 260 °C, but it's open-frame: ABS can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure.
- ASAWith caveats
With caveats. It reaches 260 °C, but it's open-frame: ASA can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure.
- Nylon (PA)With caveats
With caveats. It reaches 260 °C but is open-frame; Nylon warps in drafts and absorbs moisture. Enclosure + drying almost mandatory. For carbon-fibre variants, use a hardened-steel nozzle.
- Policarbonato (PC)Not recommended
Not recommended. With 260 °C nozzle and/or no enclosure, PC won't print reliably.
| Material | Prints it? | Why |
|---|---|---|
| PLA | Yes | Yes. PLA has no special needs: any FDM printer like the Kobra 2 prints it out of the box. |
| PETG | Yes | Yes. With a nozzle up to 260 °C and a bed up to 110 °C it comfortably meets PETG's needs. |
| TPU (flexible) | Yes | Yes. It has a direct-drive extruder, ideal for flexibles; prints TPU well (go slow). |
| ABS | With caveats | With caveats. It reaches 260 °C, but it's open-frame: ABS can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure. |
| ASA | With caveats | With caveats. It reaches 260 °C, but it's open-frame: ASA can warp and ventilation is advised. Doable in a draft-free spot or by adding an enclosure. |
| Nylon (PA) | With caveats | With caveats. It reaches 260 °C but is open-frame; Nylon warps in drafts and absorbs moisture. Enclosure + drying almost mandatory. For carbon-fibre variants, use a hardened-steel nozzle. |
| Policarbonato (PC) | Not recommended | Not recommended. With 260 °C nozzle and/or no enclosure, PC won't print reliably. |
Need the materials it struggles with? These printers handle them
Policarbonato (PC)
Sources & references
Specs cross-checked against these public sources:
- Web oficial fabricanteManufacturer page