Anycubic Kobra 2 vs Elegoo Neptune 4 Pro
👁 This comparison has been viewed 4 times · 2 this month · 0 this week
The Anycubic Kobra 2 (2023, €279) and the Elegoo Neptune 4 Pro (2023, €329) are two FDM 3D printers many people compare before buying.
The Anycubic Kobra 2 is the more affordable of the two, with a gap of about 50 (~15%) versus the other.
On the technical side, the Elegoo Neptune 4 Pro offers more build volume (225×225×265 mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Kobra 2 €279 | Elegoo Neptune 4 Pro €329 | |
|---|---|---|
| Geometry | ||
| Build volume | 250×220×220 mm 🏆 | 225×225×265 mm |
| Weight | 8.4 kg | 8.7 kg |
| Speed | ||
| Max speed | 300 mm/s | 500 mm/s 🏆 |
| Max acceleration | 5,000 mm/s² | 8,000 mm/s² 🏆 |
| Hot-end | ||
| Max nozzle temp | 260 °C | 300 °C 🏆 |
| Nozzle material | brass | brass |
| Drive type | direct | direct |
| Flow rate | — | 32 mm³/s 🏆 |
| Bed | ||
| Max bed temp | 110 °C | 110 °C |
| Bed material | PEI plate | PEI plate |
| Auto-leveling | LeviQ 2.0 auto mesh | 121-point auto mesh |
| Enclosed | No | No |
| Heated chamber | No | No |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | Yes |
| Camera | — | — |
| Calibration | ||
| Vibration compensation | Yes | Yes |
| Flow calibration | No | No |
| Input shaping | Yes | Yes |
| Pressure advance | Yes | Yes |
| Software | ||
| Official slicer | Anycubic Slicer Next | Elegoo Cura |
| OrcaSlicer | Yes | Yes |
| Noise | ||
| Noise | — | — |
| Power | 350 W | 350 W |
Verdict
- If speed matters most, the Elegoo Neptune 4 Pro wins.
- On price, Anycubic Kobra 2 is cheaper.
Frequently asked
- Which has better value: Anycubic Kobra 2 or Elegoo Neptune 4 Pro?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Anycubic Kobra 2 with 250×220×220 mm.