Anycubic Kobra 2 Pro vs Artillery M1 Pro
👁 This comparison has been viewed 2 times · 1 this month · 0 this week
The Anycubic Kobra 2 Pro (2023, €369) and the Artillery M1 Pro (2025, €349) are two FDM 3D printers many people compare before buying.
On the technical side, only the Artillery M1 Pro is enclosed (better for ABS and technical materials), and the Artillery M1 Pro offers more build volume (260³ mm).
Below is the full spec table with the best value of each feature highlighted, plus a verdict by use case.
← Swipe to see more →
| Anycubic Kobra 2 Pro €369 | Artillery M1 Pro €349 | |
|---|---|---|
| Geometry | ||
| Build volume | 220×220×250 mm | 260³ mm 🏆 |
| Weight | 8.5 kg | 14 kg |
| Speed | ||
| Max speed | 500 mm/s | 600 mm/s 🏆 |
| Max acceleration | 20,000 mm/s² | 20,000 mm/s² |
| Hot-end | ||
| Max nozzle temp | 260 °C | 320 °C 🏆 |
| Nozzle material | brass | hardened steel |
| Drive type | direct | direct |
| Flow rate | 25 mm³/s 🏆 | — |
| Bed | ||
| Max bed temp | 110 °C | 120 °C 🏆 |
| Bed material | PEI plate | PEI |
| Auto-leveling | LeviQ 2.0 | auto |
| Enclosed | No | Yes 🏆 |
| Heated chamber | No | Yes 🏆 |
| Multimaterial | ||
| AMS compatible | No | No |
| AMS type | — | — |
| AMS slots | — | — |
| Connectivity | ||
| WiFi | Yes | Yes |
| Ethernet | No | — |
| Camera | — | Yes () |
| Calibration | ||
| Vibration compensation | Yes | — |
| Flow calibration | No | — |
| Input shaping | Yes | — |
| Pressure advance | Yes | — |
| Software | ||
| Official slicer | Anycubic Slicer Next | Orca Slicer / Artillery Slicer |
| OrcaSlicer | Yes | — |
| Noise | ||
| Noise | — | — |
| Power | 350 W 🏆 | 1150 W |
Verdict
- If speed matters most, the Artillery M1 Pro wins.
- On price, Artillery M1 Pro is cheaper.
Frequently asked
- Which has better value: Anycubic Kobra 2 Pro or Artillery M1 Pro?
- See the full spec table for the best decision based on your use case.
- Which has the larger build volume?
- Artillery M1 Pro with 260³ mm.